The Original Gay Porn Community - Free Gay Movies and Photos, Gay Porn Site Reviews and Adult Gay Forums

  • Welcome To Just Us Boys - The World's Largest Gay Message Board Community

    In order to comply with recent US Supreme Court rulings regarding adult content, we will be making changes in the future to require that you log into your account to view adult content on the site.
    If you do not have an account, please register.
    REGISTER HERE - 100% FREE / We Will Never Sell Your Info

    PLEASE READ: To register, turn off your VPN (iPhone users- disable iCloud); you can re-enable the VPN after registration. You must maintain an active email address on your account: disposable email addresses cannot be used to register.

  • Hi Guest - Did you know?
    Hot Topics is a Safe for Work (SFW) forum.

i hate inches, feet and pounds and miles ?

But, I still have trouble telling what the temp is in celsuis. I think the problem is the range between the numbers is too small. If it's 32 degrees instead of 70 degrees there's a clear difference. But, if it 20 compared to 25 it's harder to judge the difference.
Well, the other way round the problem is exactly the same - and I don't think it's the spacing between the numbers. When you're talking about 32 or 70 degrees Fahrenheit I've got not the slightest idea what that could be (even more since there's no simple conversion by dividing or multiplying, like it's between cm and inches). For Celsius it works well for me - 0 is when it starts to freeze, -5 is a little cold, -20 is quite cold, and -40 is fucking cold. In the other direction +10 to +15 is good when you're going for a hike and don't want to sweat too much, +25 to +35 is quite OK to lay in the sun and just do nothing, and +40 to +50 is just too hot to leave the shadow (at least for me). And +100 is when water boils.

So I think, that you're getting used to any common unit system - that's just a matter of the regular usage of something.
 
There are vast numbers of measurement systems used throughout the world; some for historical reasons, others reflecting a cultural emphasis. And in some cases particular measurements are used for single purposes (for example, describing the height of a horse in "hands"). Just do a wikipedia search on "measurement"!

For international use, though, there is only one system, and that is the SI system, which is metric based. (There were in fact several different "metric" systems proposed over the years.) Simply for ease, most countries have adopted some or all of the SI units for common measurements such as temperature, length, mass etc. This makes global communications a hell of a lot easier.

That the US has stubbornly refused to budge from the older imperial units says something, I don't know what - even though Congress authorised metric units as long ago as 1866! I would guess that this has something to do with America's long-held national sense of self-importance, in which case - watch out! America's time in the sun, internationally speaking, seems to be going fast.

Oh, and I fully agree - dick measurements must be in inches - that should be an international standard. "Oh yeah, baby, fill me with that 22.8 centimetres!" I think not.

-T.
 
Switch to Kelvins :)

Seriously, though, Americans actually use metric all the time without realizing it There are two reasons for this:

1) The imperial system pre-dates electricity, so all the standard electrical units that you're used to (volts, amps etc) come from the SI.

2) since 1959, the remaining imperial units have been *defined* in terms of the SI. The standard inch is defined to be precisely 25.4mm. The pound is defined to be exactly 453.59237 grams.

The US has been a full member of the BIPM - the body responsible for the SI system - since its founding in 1878. It's just that the general public hasn't caught on to the fact.
 
Back
Top